Ars Vitae

Plate VIIIArms and armour

Magnetic sword frog

A printed frog shaped like a sheath. The blade drops into an open trough and is held by one rubber-faced magnet, and the Ars Vitae mark stands proud of the cover in three colours.

Render of the assembled frog from the front: the black cover with the crowned skull and hourglass raised in yellow over blue, the open trough along its top edge, and the strap arms behind.
Render of the assembled v0.7 frog; back wall and spine shaded lighter so the trough shows

The brief

A frog that reads as a sheath and gives the blade up without a fight. It is worn leaned back on a belt, hilt forward and point to the ground. The blade drops into a trough that is open along one edge and is held there by a single rubber-faced magnet; straps set the lean.

How it was made

Each version began as a say-back card: a picture of what the agent would build, and my yes before any modelling. The agent wrote the frog as a parametric model in code, checked every dimension in it and drew the proof sheets.

Before anything was printed, the predictions were sealed: ten for the cover plate and seven for the assembled frog. Both prints met all seventeen on the first try, and the fits they proved went into the shared fit table for the next part.

My Mark

Render of the cover face on: the crown, skull and hourglass in yellow, with blue showing in the crown's band and the hourglass.
The cover face on (render)

The Ars Vitae crown, skull and hourglass stand 6 mm proud of the cover, printed by height in three colours: black at the base, then a blue band, then yellow on top. The teeth are cut down to the black and the crown's band down to the blue, so the colour changes draw the detail.

Versions

  1. v0.1A closed sleeve, hanging straight.
  2. v0.2An open-topped sheath, leaned back.
  3. v0.3The same sheath on a side hanger to two belt loops.
  4. v0.4Redrawn around the real magnet.
  5. v0.5Straps in place of loops, and M3 bolts for the magnet pad.
  6. v0.6One trough for every blade but the longsword, sized from published blade specifications.
  7. v0.7The mark in raised relief on the cover, in three colours. Printed and assembled.
  8. v0.8Concept approved: a wider trough for blunt-tipped blades, a metal strip on the seat and a longer body. Not yet modelled.

Result

Every blade tried seats in the trough, a longsword feder among them. Held upside down and shaken hard, the heaviest broadsword stayed put, yet with a hand on the frog it draws free: right at the edge of too much grip, which is now the setting to keep. It has not yet been worn on the belt.